Two sets of 1/2 “ diameter nuts and bolts (our A-lock) were supplied to independent Laboratory for the vibration test. One set was made from 18-8 stainless steel and one set was made from low carbon steel. The steel bar (6.0” long x 1.0” wide x ½” thick) was attached at one end to a shaker arm, end other end of the bar was free hanging (see fig.). The nut was torqued to 45 ft/lb.
The duration of the random vibration test was one hour for each X, Y and Z axis, and subjected to a frequency ranging from 20 to 2000 Hz as shown in the data sheet below.
The test results showed no visual anomalies noted on units. The certification was issued per specification
MIL-STD-810D, Meth. 514.3, Proc. 1 Cat. 4
A breakthrough in thread design has led to the development of vibration resistant fasteners featuring a two-part design that is the SIMPLEST way to mount gears, sprockets, pulleys onto a keyless shafts.
Asymmetric Fasteners Inc.
A SUPERIOR WAY TO FASTEN ROTATING COMPONENTS.
Vibration Resistance Certified per Military Stdandard 810D Method 514.3
mounts components onto a single sleeve
call us 908-684-4025
serving industries since 1995
No additional locking devices - free turning